Rob Sharp
2020-04-30 23:46:58
So I have connected to the Bome Box ok, but my Line 6 FBV is just blinking over and over and not appearing in the settings in fact I can't choose anything in the Routing. I tried to post earlier not sure that it took, but also tried updating the firmware and waited a good 15 minutes before trying to reconnect. I also can't seem to upload a project. Man I hope I can get it working with this pedal board I have a lot riding on this project.
Steve-Bome Forum Moderator
2020-05-01 00:57:51
Hi,
Sorry for yout trouble! Is your BomeBox Power light steady or does it occasionally blink? How are you powering your BomeBox. Please do not use a USB charing port as they play with power levels and are optimized for charging batteries so do not provide consistent power. Try a power adapter or USB port that is not a charging port. If the power light blinks after it is booted then it is likely in some sort of power cycling loop.
If you are getting a steady light then power should be OK, otherwise also try disconnecting the Line 6 FBV if it is goes steady. I'm not sure how much power this device draws but if disconnecting stops the blinking, try a powered USB hub instead.
Keep me posted
Steve Caldwell
Bome Q and A Moderator and
Independent Bome Consultant/Specialist
bome@sniz.biz